CENTERFIRE
Laser Series for Ruger
®
LCR
®
Installation Instructions
Make sure the rearm is unloaded by opening the cylinder, ensuring all the
chambers are empty. Visually and physically check to ensure it is empty. Check again.
Close the cylinder. While leaving the cylinder in place, use the provided Torx wrench
to take out the factory pivot screw. In its place, install the LaserMax provided pivot
screw, making sure it is rmly seated in the frame per the Ruger instruction
manual ().
If battery installation is required (), install with the negative (–) side up, positive
(+) side against the spring. (One / Lithium included, or Two Silver Oxide
batteries).
Align the channel in the Right Housing with the trigger guard of the rearm. e top
of the laser housing should sit ush to the frame of the rearm (). Push the trigger
guard into the channel.
Bring le housing together with the right housing, making sure the activation switch
is through the hole in the housing. Squeeze the two halves together with ngers so
there is no gap (). Insert the three self tapping screws into the laser housing. Hand
tighten the screws with a small Phillips head screwdriver until they are rmly set ().
1
2
3
4
5
[–]
[+]
Insert trigger
guard into
channel
Make sure
activation switch
is through hole
in housing, then
squeeze together
until no gap,
then insert and
tighten screws
See it installed at
LaserMax.com or nd it on
LaserMax Pivot Screw
Factory
Pivot Screw
Operating Instructions
Activate the laser by pushing in on the activation switch
from either side (center position is ).
Activation
Windage
Elevation
Laser Aperture
Figure
Adjustments, Warning and
Cleaning Procedures
Check Alignment (Refer to gure A below for location of windage & elevation ports).
To check for proper alignment, turn laser on and check laser position
relative to iron sights at – yards. e laser dot should be centered
slightly above the top of your iron sights.
Adjust Alignment
If laser needs adjustment, while pointing downrange, turn windage screw
clockwise to move laser le, counterclockwise () to move laser right.
Turn elevation screw clockwise to move laser up, to move the laser down
into the proper alignment.
A slight shi in alignment may be noticed aer ring the rst few rounds aer
installing the CenterFire™ . Recheck alignment and readjust if necessary.
WARNING:
Do not turn alignment screws more than ½ turn in either direction from factory
position. is may cause damage to the CenterFire™ and may void your warranty.
Cleaning
Over time and aer numerous rounds of ammunition, your laser lens could
become clouded with gun shot residue. In order to remove this residue:
Keep rearm pointed in a safe direction. Be sure to unload your rearm
by opening the cylinder and checking that the chambers are empty. Keep
hands from passing in front of the muzzle. Conrm laser is o.
Take a standard cotton swab and dampen end with isopropyl alcohol.
Apply dampened swab to the laser lens, and rotate in a small circular pattern
removing any residue. Be sure to clean around the edges of the lens.
For best results, it’s recommended that the laser lens is cleaned at
the end of each day you shoot – similar to routine rearm cleaning.
•
•
•
*
Spare Parts List:
–
–
–
––
––
/
Patent Pending
01785–0–41 REV A
08/31/12
™
Easy To Use, Easy To Install
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales